FREE SHIPPING – SOME EXCEPTIONS MAY APPLY
The Muskoka is a smaller version of the Muskoka 2. Just over 1000 sq’ on 2 levels it features 2 decks on the upper level. This model is manufactured with 70mm (2-3/4″) thick wall logs. A great seasonal cabin or an affordable starter home. (sq footage is based the total footprint, living space could be less, see floor plans)
FREE STRUCTURAL ENGINEERING – PREMIUM models include site specific engineering stamped by a licensed engineering firm for roof and wind loads. Additional engineering services are available on request
Tip: Mineral wool insulation is recommended for log construction. It’s impervious to moisture with a higher R-value per inch than fiberglass, reduces noise levels & is environmentally friendly
Insulating the roof: Apply locally supplied materials to add rafters over the tongue & groove roof 
boards. The build up depth is determined by the required R-value in the ceiling to meet local building codes. High density spray foam provides maximum benefits, highest R-value for thickness & is water proof. These added rafters also increase the roof load capacity
Assembly: The model can be assembled in approximately 10 days or less with 3 people
Tip: House wraps & vapor barriers are required in most regions when insulating. Vapor barriers are installed on the warm side of walls, interior of the studs for cold climates and exterior of studs for hot climates
Building Codes: Premium series homes & cabins are manufactured to meet all structural requirements for building codes including, California Title 24, earthquake, heavy snow load regions and hurricane zones
Kit Includes:
- no floor, ready to assemble on a concrete slab or wood foundation
- pre-cut, numbered exterior walls
- pre-cut, numbered interior walls
- pre-cut, numbered gable components
- 7/12 roof pitch (30 degrees)
- vaulted, cathedral ceilings
- pre-cut, 100mm x 200mm (4″x8″) numbered glulam roof purlins/beams, spaced 558mm (22″) or less
- pre-cut, numbered (18mm) 3/4″ tongue & groove roof boards
- pre-cut, numbered fascia boards
- pre-cut 100mm x 200mm (4″x8″) numbered glulam floor beams, spaced 558mm (22″) or less
- pre-cut loft floor boards 28mm (1-18″)
- stairs, handrails, built to meet codes
- 2 interior doors 900mm x 2040mm (36″x80″)
- 1 single wide wood windows 765mm x 990mm (30″x39″)
- 4 single wide wood windows 530 x 530 (21″ x 21″)
- 3 double wide wood windows 1530mm x 990mm (60″x39″)
- 1 exterior doors 914mm x 2040mm (36″x80″) 1/2 glass tempered
- 2 exterior doors 813mm x 1930mm (32″ x 76″) 1/2 glass tempered
- 2 covered decks on loft floor
- 4 adjustable posts – 2 under each covered deck
- prebuilt deck railings with vertical balustrades
- hardware for doors & windows
- 2 spare wall logs/spare roof boards
- 8″ log screws to connect each row, gable components, purlins
- packaged/wrapped and marked for sequence of assembly
